Page 1 of 1

QP Update 6.72.131

Posted: Sun Mar 03, 2019 1:19 pm
by Sonideft
This is a minor incremental release to improve support for Standard Units (ft, inches, pounds...) for some users.

In the Sags & Tensions Calculator, Stringing Charts can now be generated in Standard Units. Beyond basic conversions, the Weather Loads Cases are now evenly separated and aligned in 10 degree F increments.

For Projects, the Settings Tab can now easily be edited in either Standard or Metric Units. The Tab will respond immediately to changes to the units desired for the project.

More Standard Units support to follow.